Bill Williams (IT): Support Site
[home]
|
[profile]
|
[register]
|
[help]
|
[Contact Us]
Revise: Large Lathe (now donated to Gayle Mills)
Note: You must be registered in order to post a Topic or Comment.
To register,
click here
.
Note: Only the poster of this message, and the moderator can edit the message.
Your UserName:
Your Passkey:
Forgot your passkey?
[Click Here]
Subject:
Byline:
for Staff use.
Body Text:
For a guide to
embellishing
the text,
click
here
[h3]Industrial Quality Lathe for Sale (now donated to Gayle Mill)[/h3] Holbrook Lathe: ideal for Steam-Roller/Steam-Tractor enthusiast. Powered traverse and powered cross-slide. Full screw-cutting facilities Whitworth & Metric, with all the relevant change gearwheels included. Half-horsepower electric motor available in full working order. Two three-jaw and two four-jaw chucks and two faceplates, plus a full set of seven collets for working on rods. Eight speeds (RPM): 400, 250,160, 100 with backgear: 44,27,17,11 Formerly used by the engineering dept at Imperial College London, this lathe has been installed in my garage for over 30 years. Reluctantly I have decided that I really don't use it enough and it would probably be more gainfully employed with someone else. [imgl]/photos/lathe7_300.jpg[/imgl] [mag]/photos/lathe7.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe3_300.jpg[/imgl] [mag]/photos/lathe3.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe8_300.jpg[/imgl] [mag]/photos/lathe8.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe4_300.jpg[/imgl] [mag]/photos/lathe4.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe5_300.jpg[/imgl] [mag]/photos/lathe5.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe6_300.jpg[/imgl] [mag]/photos/lathe6.jpg[/mag] click to magnify. [br][/br] [imgl]/photos/lathe9_300.jpg[/imgl] [mag]/photos/lathe9.jpg[/mag] click to magnify. [br][/br] We will assist in dismantling transporting and re-installing this lathe as we really want it to go to a 'good home' [:)] Bill. Revised by - Bill Williams on 14 May 2006 at 19:32:06 Revised by - Bill Williams on 6 Dec 2017 at 13:26:40
Check here to include your profile signature.
Check here Remember Details.
Go to Home Page